Flap Deleter - Deactivate flap control
Would you like to deactivate the exhaust flap?
With the flap deleter you can prevent entries in the fault memory
e.g. if an exhaust without an exhaust flap is installed or the exhaust flap is deactivated.
- Easy plug-n-play installation.
- No programming.
- Easy to remove again.
- No modifications to the vehicle necessary.
- No error message in the error memory.
- For electronic exhaust flap on the rear silencer
- for vehicles with 3-pin connection
- Quality product made in Germany
Please state the exact vehicle type when ordering.
Installation is completed in 5 minutes for most vehicles.
The device is plugged into the outside of the vehicle in front of the exhaust flap.
The actuator can remain installed on the vehicle.
For vehicle models with electric exhaust flaps
Two items are required for vehicles with two flaps.
Not suitable for vacuum-controlled flaps.
Not suitable for diesel vehicles or flaps involved in exhaust gas purification.
Also available for other brands.
Safety instructions:
- Installation may only be carried out by electronics or mechatronics specialists.
- De-energize before installing or opening the housing.
- Electrical or electronic products can pose a risk of fire or electric shock.
- The control unit is designed for motorsport and show purposes, no approval for road traffic, no TÜV or ABE certificate.
- Use and installation at your own risk, no liability for damage.
- Incorrectly set controls can lead to damage to the engine or vehicle (e.g. closed flap at full load).
- Please ensure that the seals and connections of the product are clean, intact and correctly seated before and after installation, otherwise defects or damage may occur.
- Check the product carefully for integrity before use and installation. If you notice a defect, do not use the product and contact us.
- Only use the product for the specified installation purposes and check its usability before installation or use. If you have any questions, please contact us.
